Plumbing

Bathroom Additions and Remodel Plumbing in Memphis, TN

We handle the plumbing side of bathroom additions and remodels, from moving a drain to setting a new shower valve, toilet and sink. We work with your contractor or on our own scope.

A bathroom is one of the most plumbing-heavy rooms in a house. A remodel might move a toilet, change a tub to a walk-in shower, add a second sink or replace the old valves behind the wall. An addition means new supply lines, new drains and a vent, all connected correctly to the rest of the house. We do the plumbing for these jobs and coordinate with the people doing the rest of the work.

The work happens in two stages. Rough-in comes first, while walls and floors are open: we run the water supply lines, drains and vent pipes and set the shower valve at the right height. Then comes the finish stage after the tile, vanity and walls are done, when we set the toilet, sink, faucets, shower trim and any other fixtures. Rough-in work is typically inspected before it is covered, and we explain which steps apply to your project.

Drain slope, venting and shutoff access matter as much as the fixtures themselves. A drain that is set at the wrong height or slope can slow down and clog, and a missing vent lets sewer odors into the room. We plan these details before the walls close. If your existing pipe is old or undersized, we tell you before the remodel, not after the tile is down.

When to bring in a plumber for a bathroom project

  • You are adding a bathroom, or finishing a basement, attic or garage bathroom.
  • You want to move the toilet, shower, tub or sink to a different wall.
  • You are replacing a tub with a shower, or the reverse.
  • The shower valve or old supply lines behind the wall are leaking or hard to turn.
  • The remodel plan adds fixtures, such as a double vanity or a second shower head.
  • Your contractor needs the plumbing roughed in before drywall and tile go up.

How a visit goes

  1. Review the plans and the spaceWe look at the layout, existing pipes and drain locations, and where each fixture will go. We check access under the floor or from the attic, and note anything that affects the plan.
  2. Rough in the plumbingWe run supply lines, drains and vents, set the shower or tub valve and test the pipes before they are covered. Rough-in is typically inspected, and we explain the steps for your address.
  3. Coordinate with the other tradesWe work around your contractor, tile setter and electrician so the fixtures land where they should and nothing has to be torn out later.
  4. Set the fixtures and testAfter the finish work, we install the toilet, sink, faucets and shower trim, check every connection for leaks, confirm drains run freely and show you the shutoffs.

Questions we hear

Can you add a bathroom where there is none?

In many houses, yes. It depends on where the water supply and drain lines are and what can be reached. We look at the space, tell you what it takes to connect the new bathroom, and explain any permit and inspection steps.

Do I need to hire you and a separate contractor?

Not necessarily. If you already have a remodeler, we coordinate with them. If you want us to handle the plumbing scope only, we can do that.

Will moving a toilet or shower be a big job?

It depends on how far it moves and what is under the floor. Short moves on an open floor are simple. Moving a drain across joists or onto a slab takes more planning. We look at it before telling you what to expect.

Should I buy the fixtures before the plumbing is roughed in?

Yes, or at least pick them. Rough-in dimensions depend on the exact toilet, valve and sink you choose, so we need the model information early.

Do I need a permit?

Additions and many remodels do need a permit and inspection. Requirements vary by project and location. We tell you what applies once we see the scope.

Send us a request

Tell us what is going on and we will get back to you.

Based in Cordova, TN 38018.

Request an estimate

What do you need?
Call nowRequest an estimate