Gas Lines

Gas Line Installation in Memphis, TN

New gas piping for a range, dryer, water heater, fireplace, grill or generator, sized for the load, pressure tested and installed to code.

A gas line is only as good as its planning. Before any pipe is cut, we add up the gas demand of every appliance on the line, measure the distance from the meter or tank, and size the pipe so each appliance gets the pressure and volume it needs. A pipe that is too small will starve appliances when several run at once.

We work with the materials that suit the job. Black iron pipe is common for indoor runs. Flexible corrugated stainless steel tubing, known as CSST, is often used inside homes and must be bonded as required. Coated steel or polyethylene pipe is used underground, with the correct fittings, depth and warning tape. Each appliance gets its own shutoff valve and an approved connector, and certain appliances need a sediment trap, also called a drip leg.

Safety checks are part of the job. After the pipe is installed, we pressure test the system and check every joint before gas is turned on. We confirm that appliances are vented correctly and that there are no leaks at connections. New gas piping is normally permitted and inspected, and we handle both where required. Then we show you where your shutoff valves are and how to use them.

When you need a new gas line

  • You are switching from an electric range, dryer or water heater to gas.
  • You are building or remodeling a kitchen, laundry room or bathroom and need to move gas piping.
  • You want gas to an outdoor kitchen, grill, fire pit or fireplace.
  • You are adding a standby generator, pool heater or garage heater.
  • Your current gas line is too small for the appliances on it.
  • If you smell gas, leave the home first. Do not use switches or phones inside. Call 911 or MLGW from outside. Then call us for the repair.

How a visit goes

  1. We review the job and the loadWe look at where the gas supply is, where each appliance will go and what it needs. We add up the demand and check that the meter and the existing piping can serve it.
  2. We plan the route and the permitWe choose the pipe material and route, decide where the valves and sediment traps go and file for the permit where one is required.
  3. We install the pipingWe cut, thread or join the pipe, support it correctly, bond CSST where required, protect it where it passes through walls or the ground and add a shutoff at each appliance.
  4. We test, inspect and turn it onWe pressure test the new line, arrange the inspection, connect and light the appliances with the utility coordinated if service has to be restored, and check each connection for leaks.

Questions we hear

What should I do if I smell gas?

Leave the home right away. Do not use switches or phones inside, and do not light anything. From outside, call 911 or the gas utility, MLGW. Stay out until you are told it is safe. After that, we can find and repair the cause.

Can you run gas to an outdoor kitchen or fire pit?

Yes. We bury the pipe at the required depth with warning tape, or run it along a structure with the proper protection, and we install a shutoff valve at the appliance. We also check that your supply can handle the added load.

Do I need a permit?

Usually yes, where required. New gas piping is normally permitted and inspected. We explain what applies to your job and handle the paperwork.

Can you convert an electric appliance to gas?

Often, yes. It takes a gas line to the appliance location and a gas-ready appliance. For dryers and ranges we also check ventilation and clearances. We let you know what your home needs before work starts.

Send us a request

Tell us what is going on and we will get back to you.

Based in Cordova, TN 38018.

Request an estimate

What do you need?
Call nowRequest an estimate