Natural gas has an added odor so that leaks are easy to notice. It smells like rotten eggs or sulfur. A leak can come from a loose or worn appliance connector, a corroded pipe, a failed fitting, a damaged line from digging or a faulty valve. In every case, the first response is to leave, call for help from outside and let the utility respond. Repair comes after.
When the emergency is over, we find the source of the leak. We use electronic gas detectors that can pick up small amounts of gas and leak-detecting solution that bubbles at the point of leakage. We check appliance connections, valves, fittings and the visible pipe. For hidden or underground piping, a pressure test shows whether the system holds, and we narrow down where the loss is.
Repairs depend on the cause. A loose connection may only need to be tightened and retested. Worn flexible connectors are replaced. A corroded pipe or a bad fitting is cut out and replaced with new pipe and fittings. If an underground line is damaged, we plan the repair or replacement of that section. Then we pressure test the entire repaired system before gas goes back on. The utility may need to shut off or restore service at the meter, and we coordinate with it.
Signs of a gas leak
- The smell of rotten eggs or sulfur. Leave the home first, do not use switches or phones inside and call 911 or MLGW from outside.
- A hissing or whistling sound near a gas pipe, meter or appliance.
- Dead or discolored vegetation in a line above a buried pipe.
- Bubbles in wet ground or standing water near a gas line.
- A gas appliance with a yellow or orange flame, or soot around it.
- A gas bill that jumps without a change in how you use gas. Have it checked.
How a visit goes
- First, you leave and the utility respondsIf you smell gas, everyone and every pet leaves the building. Call 911 or MLGW from outside. The utility makes the situation safe, and we start after you are told it is safe to return.
- We locate the leakWe use gas detectors, leak-detecting solution and a pressure test to find where gas is escaping. We look at connectors, valves, fittings and pipe, and we check for damage from digging, corrosion or movement.
- We repair or replace the damaged partWe tighten, replace or cut out and rebuild the section that is leaking. We use approved pipe, fittings, connectors and thread sealants for gas.
- We pressure test and confirmWe pressure test the repaired system, check every joint and appliance, arrange the inspection where required and coordinate with the utility to restore service.
Questions we hear
Can I look for the leak myself?
No. If you smell gas, leaving is the first step. Do not search for the source or try to fix it. Do not use flames, switches or phones inside. Call 911 or MLGW from outside.
Who turns the gas off?
The gas utility controls the meter, and in an emergency they respond. We can close appliance valves and tell you where your shutoffs are, but we coordinate with the utility to shut off and restore service at the meter.
Is a pilot light that keeps going out a leak?
Not always. It can be a draft, a worn thermocouple or a dirty pilot. If you smell gas, leave first. If you do not, do not keep relighting it. Call us to inspect the appliance.
Will you test the whole system after the repair?
Yes. We pressure test the repaired piping, check every joint, check appliance connections and make sure there are no leaks before you use gas again.