Faucets and fixtures are the parts of your plumbing you use every day, so small problems get noticed fast. A faucet that drips usually has a worn cartridge, washer or seat inside. A faucet with weak flow often has mineral buildup in the aerator or a partly closed shutoff valve under the sink. If the faucet body is corroded or the finish is failing, replacement is cleaner than another repair.
We install new faucets in kitchens, bathrooms and laundry areas, along with showerheads, tub spouts, shower valves and supply lines. If you buy your own fixture, bring us the model and we check that it fits the sink or shower you have. If the old shutoff valves under the sink are stuck or leaking, we replace them during the same visit so the next repair is easier.
Garbage disposals are the other common call. A disposal that hums but does not turn is often jammed, and a disposal that leaks may have a failed seal or a loose drain connection. We can free a jam, repair a leak or install a new unit. We also check the sink drain and trap, since a slow kitchen sink is often a drain problem rather than a disposal problem.
Signs a faucet, fixture or disposal needs work
- A faucet drips from the spout or leaks around the handle or base.
- Water pressure from one faucet is weak while the rest of the house is fine.
- A handle is stiff, loose, or does not shut the water off fully.
- There is water under the sink, on the cabinet floor or around the shutoff valves.
- The disposal hums, trips its reset button, smells bad or leaks underneath.
- The showerhead sprays unevenly or the shower valve will not hold temperature.
How a visit goes
- Look at the fixture and the supplyWe check the faucet or fixture, the supply lines, the shutoff valves and the drain beneath it. We ask you when the problem started and whether it changes with hot or cold water.
- Explain repair or replacementIf a cartridge, washer or aerator will fix it, we tell you. If the fixture is worn out or the part is no longer available, we go over replacement options with you.
- Repair or installWe shut off the water, make the repair or install the new faucet, fixture or disposal, and replace worn supply lines or shutoff valves as needed. We connect the drain and electrical for a disposal as required.
- Test and tidyWe run hot and cold water, check for leaks above and below the sink, test the disposal if we worked on one, and wipe down the area.
Questions we hear
Why is my faucet dripping?
Most drips come from a worn cartridge, washer, O-ring or seat inside the faucet. The right fix depends on the faucet type, and we identify it before replacing anything.
Should I repair or replace a leaking faucet?
If the faucet is in good shape, a new cartridge or seals can make it work like new. If the body is pitted, corroded or the parts are hard to find, a new faucet makes more sense.
My garbage disposal hums but will not spin. What should I do?
Turn off the disposal and the power at the wall switch. Some units have a hex socket on the underside to turn the blades by hand, and a reset button on the bottom. Never put your hand in the disposal. If it still will not run, call us.
Can you install a faucet or fixture I bought myself?
Usually yes. Check that it fits the hole spacing of your sink and tell us the model when you call. We confirm everything is compatible before we start.
What do I do if a shutoff valve under the sink leaks or will not turn?
Do not force it, because a stuck valve can break. Shut off the main water if needed and call us. We replace worn shutoff valves so you can isolate the fixture next time.