Electrical

Ceiling Fan Installation in Memphis, TN

A ceiling fan moves air and cuts down on how hard your AC works. We mount it on a fan-rated box, wire it correctly and make sure it runs without wobble.

A fan is heavy and it moves. A normal light box in the ceiling is not built for that, and a fan hung from one can loosen over time or even fall. The first thing we check is the box and what it is attached to. If it is not fan-rated, we replace it with one that is, anchored to a joist or a brace between joists.

We install new fans where there was a light, replace old fans, and add a fan in rooms that have no ceiling fixture at all. In that case, we run new cable from a nearby switch or junction and cut in the box. We wire fan and light separately when you want to control them separately, and we install wall controls, remote receivers or smart controls as you prefer.

Choosing the fan matters too. Size should match the room, the blade height should be right for the ceiling and the fan should be rated for the place it goes. A porch or covered patio needs a damp-rated or wet-rated fan. Rooms with low ceilings may need a flush-mount model. We can help you pick one, or install the one you already have.

Signs you need a fan installed or replaced

  • The room is hot, stuffy or hard to cool, and you have no fan.
  • Your current fan wobbles, clicks or makes a grinding noise.
  • The fan runs at only some speeds, or the light kit has stopped working.
  • The fan hangs from a regular light box that was never meant to hold it.
  • You want to control the fan and light separately, or with a remote.
  • You are putting a fan on a porch, patio or in a bedroom for the first time.

How a visit goes

  1. We check the ceiling and the boxWe find out what is above the ceiling, check the existing box and decide whether we can use it or need to install a fan-rated support.
  2. We prepare the wiring and controlsWe turn off power at the panel, run any new cable and set up the switching you want, whether that is one wall switch, a separate fan and light control or a remote.
  3. We assemble and mount the fanWe assemble the fan, hang it from the bracket, connect the wires, attach the blades and light kit and tighten every fastener.
  4. We balance and testWe run the fan on every speed, check for wobble and noise, adjust the blades if needed and confirm that the controls and lights work.

Questions we hear

Can I put a fan where I have a regular light fixture?

Often yes, but the box has to be replaced or reinforced if it is not rated for a fan. We check this on every job. It is not a place to cut corners.

Do I need a fan with a light kit?

No. You can choose a fan with or without a light. If you have a fan and a light on separate switches, we can keep them that way.

Why does my new fan wobble?

Small differences in blade weight, a loose bracket or a box that is not secure can all cause wobble. Most wobble is fixed by tightening and balancing. If the box moves, it needs to be replaced.

Can you install a fan outside?

Yes, if the fan is rated for damp or wet locations, depending on whether it is covered. We use weather-rated parts and GFCI protection where required.

Send us a request

Tell us what is going on and we will get back to you.

Based in Cordova, TN 38018.

Request an estimate

What do you need?
Call nowRequest an estimate