Your panel, also called a breaker box, takes power from the utility and divides it into circuits. Each circuit has a breaker that trips if there is too much current. Panels do not last forever, and homes today use far more power than they did when many panels were installed.
An upgrade can mean replacing the panel with a new one of the same size, or increasing the service, for example to 200 amps, to handle central air, an electric range, an EV charger or a new addition. Larger service may also need a new meter base, a new service cable and a new grounding system. Utility coordination is part of the job, because the power has to be disconnected and reconnected by the utility.
We size the panel with a load calculation, not a guess. Then we install the new panel, move each circuit over, label every breaker and add protection such as AFCI and GFCI where required. If your home has a panel known for problems, or breakers that no longer trip when they should, replacing the panel is often the safest answer.
Signs you may need a panel upgrade
- The panel is full, with doubled-up breakers or no room for new circuits.
- Breakers trip often, or feel hot or loose.
- You see rust, scorch marks or water stains on the panel.
- Your panel makes buzzing or crackling sounds.
- Fuses are still in use, or the panel is a model with a known history of problems.
- You are adding central air, a hot tub, a workshop, an EV charger or a home addition.
How a visit goes
- We assess the existing panelWe open the panel, check the breakers, wire condition and grounding, and look at the service size. We also add up the loads you have and the ones you plan to add.
- We plan and permit the jobWe choose the panel and service size, plan the layout and file for the permit where one is required. We coordinate with the utility when service needs to be disconnected.
- We replace the panelPower is off for part of the job while we remove the old panel, mount the new one, connect every circuit and install protective devices. We schedule it with you so you know when to expect the outage.
- We inspect, label and restore powerWe test each circuit, label the directory, arrange the inspection and have the utility reconnect service as needed. Then we show you where the main shutoff is.
Questions we hear
How do I know what size panel I need?
It depends on the loads in your home now and the ones you plan to add. We do a load calculation that considers appliances, heating and cooling, and future items such as an EV charger. Most homes use 100, 150 or 200 amps.
Will the power be off during the upgrade?
Yes, for part of the job. We plan the work so the outage is as short as it can be, and we tell you in advance when it will happen.
Do I need a permit and inspection?
Yes, panel replacement is work that requires a permit and an inspection where the local authority requires it. We take care of this as part of the job.
Can the panel be replaced if my home still has fuses?
Yes. Replacing a fuse box with a modern breaker panel is common. It often brings better protection and room for added circuits.