Electrical

Wiring & Rewiring in Memphis, TN

Old, damaged or undersized wiring can overheat or fail. We run new circuits, replace unsafe wiring and rewire homes room by room or as a whole.

Wiring is the part of your electrical system that you never see until something goes wrong. Cable gets old. Insulation turns brittle, connections loosen, past remodels leave hidden splices and a home built for fewer appliances may no longer be able to carry what you plug in today.

We do both small and large wiring jobs. New wiring means running cable for a new circuit, a room addition, a finished basement, a garage or a workshop. Rewiring means replacing old or unsafe wiring, such as knob-and-tube, cloth-covered cable, ungrounded circuits or aluminum branch wiring. We can rewire in stages so you can keep living in the house.

Good wiring work includes planning. We map the circuits, decide how many you need and size breakers and conductors to match. We add grounding, AFCI and GFCI protection where required, label the panel and seal holes we cut in the walls. Where a permit and inspection are required, we handle them.

Signs your wiring needs attention

  • Your home has knob-and-tube wiring, cloth-covered cable or two-prong outlets.
  • Breakers trip often, or lights dim when large appliances start.
  • You see discolored outlets, frayed cable or hear crackling inside walls.
  • A past remodel left open splices, extension cords or loose connections in the attic or basement.
  • Your home has aluminum branch wiring.
  • You are adding a room, garage or workshop that needs new circuits.

How a visit goes

  1. We inspect and map the systemWe look at the panel, trace circuits, check accessible wiring in the attic, crawlspace and basement, and test grounding. Then we explain what we found.
  2. We lay out a planWe decide which circuits to add or replace, how to route the cable with the least damage to walls and what can be done in stages if you prefer.
  3. We run and connect the new wiringWe pull cable, install boxes, make secure connections and tie into the panel. We protect the cable where it passes through framing and keep it neatly supported.
  4. We test, label and close upWe test every circuit, label the panel, repair the openings we made where that is part of the job and arrange the inspection where one is required.

Questions we hear

How do I know if my house needs rewiring?

The age of the house is only a clue. What matters is the type of wiring, its condition and how the circuits are loaded. An inspection of the panel, accessible runs and outlets tells us whether you need spot repairs, new circuits or a full rewire.

Will rewiring tear up my walls?

Some opening is usually needed, but there are ways to limit it. We use attics, crawlspaces and basements to run cable, and fish wire inside walls when we can. Where we must cut drywall, we plan the cuts to keep patching small.

Can I stay in the house during rewiring?

Often yes. We can work circuit by circuit and keep power on in the rest of the house. We tell you in advance which areas will be without power while we work.

Do I need a permit for wiring work?

In most cases, new circuits and rewiring need a permit and an inspection where required by the local authority. We tell you what applies and take care of it.

Send us a request

Tell us what is going on and we will get back to you.

Based in Cordova, TN 38018.

Request an estimate

What do you need?
Call nowRequest an estimate