Electrical

Outlet & Switch Installation in Memphis, TN

We replace worn outlets and switches, add new ones where you need them and install GFCI, USB and dimmer devices. Every device is wired and tested to code.

Outlets and switches wear out. Contacts loosen, plugs fall out of the wall, switches crackle or feel warm. Replacing them is a small job, but it has to be done carefully because a poor connection at a device is one of the most common sources of heat in a home.

We also add outlets where you do not have enough of them. That can mean extending an existing circuit to a new box in the wall, or running a new circuit for a kitchen appliance, a garage tool bench or a window air conditioner. Older homes with two-prong outlets can often be brought up to date with GFCI protection and proper grounding where the wiring allows it.

Modern codes call for specific protection in specific places. Kitchens, bathrooms, garages, laundry rooms, basements and outdoor outlets need GFCI protection. Bedrooms and living areas often need AFCI protection. We install the right device for each location, and we install tamper-resistant receptacles where they are required.

Signs your outlets or switches need work

  • Plugs fit loosely or slip out of the receptacle.
  • An outlet or switch is warm, discolored or smells like burning plastic.
  • A switch crackles, buzzes or works only some of the time.
  • You rely on power strips and extension cords because there are not enough outlets.
  • Your home still has two-prong outlets with no ground.
  • Bathroom, kitchen or outdoor outlets have no GFCI test and reset buttons.
  • You want a dimmer, a smart switch or USB outlets.

How a visit goes

  1. We look at the circuitWe check what the outlet or switch is connected to, what wire is behind it and whether the circuit can handle the load you plan to add.
  2. We choose the right deviceWe pick a receptacle or switch rated for the circuit and the location. That might be GFCI, AFCI, tamper-resistant, weather-resistant, USB or a dimmer matched to your bulbs.
  3. We install and connectWe shut off the power, cut in new boxes where needed, make tight connections, ground the device and fit the cover plate. If we run new cable, we protect it and route it cleanly.
  4. We test everythingWe test polarity, grounding and the GFCI function with a tester, then turn the circuit back on and confirm that everything works before we leave.

Questions we hear

Can you add an outlet where there is none?

Usually yes. We look at the nearest circuit with capacity, check how the wall is built and decide whether we can fish the cable inside the wall or need a different route. Some walls are easy, and some take more work.

What is a GFCI outlet and do I need one?

A GFCI outlet shuts power off in a fraction of a second if it senses current leaking where it should not, for example through water. Code calls for them in wet and damp areas such as bathrooms, kitchens, garages and outdoors.

Can I replace my two-prong outlets with three-prong ones?

Only if there is a ground, or if the circuit is protected by a GFCI and the outlet is labeled "no equipment ground." Putting a three-prong outlet on an ungrounded circuit without that protection is not safe. We check which case you have.

Why does my switch feel warm?

A lightly warm dimmer can be normal. A switch that is hot, discolored or buzzing is not. It can mean a loose connection or a load that is too large for the device, and it should be checked.

Send us a request

Tell us what is going on and we will get back to you.

Based in Cordova, TN 38018.

Request an estimate

What do you need?
Call nowRequest an estimate