Plumbing

Leak Detection & Repair in Memphis, TN

A hidden leak can damage floors, walls and your water bill for a long time before you see it. We find where the water is escaping, then repair it.

Some leaks announce themselves with a puddle or a drip. Others sit behind a wall, under a slab or in the ceiling and only show up as a stain, a smell or a higher water bill. Leak detection is the work of tracing the water back to its source, and leak repair is fixing the pipe, joint, fitting or fixture that has failed.

A good detection process works by narrowing things down. We check the water meter with every fixture off to see whether water is moving when it should not be. We test the pressure in the system, look at shutoff valves, supply lines and fixtures, and use tools such as moisture meters and acoustic listening equipment to pinpoint a leak behind a surface without cutting into it more than necessary.

Repair depends on what failed and where. A worn supply line or a leaking fixture connection is a quick fix. A pinhole in copper, a failed joint or a damaged section of pipe may need that section cut out and replaced. If a line under the slab or in a wall keeps failing, we talk with you about other options, including rerouting or replacing the pipe.

Water damage gets worse the longer it goes. If you see a leak, shut off the water to the affected fixture, or at the main valve if you cannot find the source, and call us.

Signs you may have a water leak

  • A water bill that has gone up without any change in how you use water
  • The water meter keeps moving when every fixture is off
  • Damp, stained or bubbling spots on walls, ceilings or floors
  • A musty smell, or mold in an area that stays damp
  • The sound of running water when nothing is on
  • Low water pressure that appeared without explanation
  • A warm spot on the floor, which can point to a leak in a hot water line

How a visit goes

  1. We start with what you have seenYou tell us where the damp spots, stains or sounds are and what changed on your bill. Then we check the meter and the shutoff valves.
  2. We trace the leakWe test the system and use moisture and listening equipment to locate the leak. Where we can, we find it without opening more of your home than needed.
  3. We explain and repairWe show you what failed, explain the repair and carry it out. If a section of wall or floor has to be opened, we tell you before we do it.
  4. We confirm the leak is stoppedAfter the repair we check the system again, including the meter, to confirm the water is no longer escaping. We also point out any damage you may want to have dried or repaired.

Questions we hear

How can I check for a leak myself?

Turn off every faucet and appliance that uses water, then look at your water meter. If the dial or the low-flow indicator is moving, water is going somewhere. Also check under sinks, around the toilet base and the water heater for damp spots.

Do you have to cut into my walls or floor?

Sometimes it is necessary to reach the pipe. We try to pinpoint the leak first so any opening is as small and in as precise a spot as possible, and we tell you before we do it.

Could the toilet be leaking even if I do not see water?

Yes. A toilet that runs or refills on its own can waste a lot of water into the bowl without any puddle. Adding a few drops of food coloring to the tank and checking whether color appears in the bowl without flushing is a simple test.

Will my homeowner insurance cover it?

That depends on your policy and the cause of the damage, so we cannot say. Documenting the damage and what was repaired helps if you decide to file a claim, and we are glad to explain what we found.

Send us a request

Tell us what is going on and we will get back to you.

Based in Cordova, TN 38018.

Request an estimate

What do you need?
Call nowRequest an estimate