The pipes that bring water to your faucets, showers, toilets and appliances do not last forever. Over time, galvanized steel pipe corrodes from the inside and narrows, copper can develop pinhole leaks, and some older plastic piping becomes brittle. When leaks keep showing up in different places, patching one section at a time stops making sense, and replacing the supply lines throughout the house is the sound fix.
Repiping covers the supply side only: the lines that carry clean water in. It does not include drain lines, which carry waste out. Modern supply piping is usually PEX, a flexible plastic tubing, or copper. PEX is easier to route through walls and does not corrode, while copper is rigid and has a long track record. We talk through which one fits your house, your budget and how much wall and ceiling access there is.
Because pipes run inside walls, floors and ceilings, repiping usually means opening small sections of drywall to run new lines. We plan those openings to keep the damage low and tell you ahead of time where they will be. Work of this size usually involves a permit and an inspection, and we explain what applies to your address.
Signs your house may need repiping
- Leaks keep appearing in different spots, especially pinhole leaks in copper or leaks at fittings.
- Water pressure is low throughout the house even though the city supply is fine.
- Water runs brown, yellow or rusty, mostly after it has sat in the pipes for a while.
- You can see green or white crust, flaking or rust on exposed pipes in the crawlspace, basement or utility room.
- Your house has galvanized steel supply pipe or gray polybutylene plastic, both of which are known for failing with age.
- Water stains, soft spots or a musty smell show up on walls, ceilings or floors with no obvious source.
How a visit goes
- Inspect and identify the pipeWe look at the pipe material, the main shutoff, the water heater connections and the places we can reach. We ask about leaks and pressure you have noticed, and we check whether a spot repair or a full repipe makes more sense.
- Plan the route and the openingsWe choose where the new lines will run, which walls or ceilings need small openings, and how to keep the water off for as short a stretch as possible. We go over the plan with you, including the permit and inspection steps.
- Install the new supply linesWe run new piping to every fixture, connect to the main and the water heater, and install new shutoff valves where needed. We pressure test the system before anything is closed up.
- Restore water and walk the houseWe turn the water back on, check each fixture for leaks and flow, flush the lines and show you where the main shutoff is. We explain what drywall patching is left to do.
Questions we hear
How do I know if I need a full repipe or just a repair?
One leak in one spot on otherwise healthy pipe is usually a repair. Repeated leaks in different places, widespread rust-colored water, or a pipe material known to fail with age point toward repiping. We inspect first and tell you which one fits.
Do I have to move out while you work?
Most people stay home, but the water will be off for part of the job. We explain how the work is staged so you know when you will have water and when you will not.
Will you have to cut into my walls?
Often, yes, in small sections. Pipes are hidden, so we open only what we need to run the new lines. We tell you where before we start. Patching and painting the drywall is a separate step we discuss with you.
Is repiping covered by homeowners insurance?
It depends on your policy and on what caused the damage. Policies often cover sudden water damage but not wear and age. Ask your insurer, and we can give you the details of what we found to share with them.
What about the manufacturer warranty on the pipe?
Warranties on pipe and fittings vary by product and manufacturer. We explain what applies to the materials we recommend for your house.