If you smell gas, leave the home right away. Do not use light switches or phones inside. Call 911 or the gas utility (MLGW) from outside. Do not go back in until you have been told it is safe.
A tankless water heater has no storage tank. When you open a hot tap, water flows through the unit and is heated on the way. Because it does not keep a tank of hot water warm all day, it can run out of hot water only when demand is more than the unit can heat at one time. It also takes up much less space, and many models mount on a wall.
Tankless units are not a simple swap for a tank. Gas models often need a larger gas line than a tank heater does, and they need proper venting, usually through special pipe. Electric models can draw a lot of power and may need a dedicated circuit or a panel upgrade. The unit also has to be sized for how many fixtures run at once and for the temperature of your incoming water. We look at all of this before recommending a model.
Tankless heaters also need maintenance. Hard water leaves mineral scale inside the heat exchanger, and that scale reduces performance and shortens the life of the unit if it is never flushed. Descaling is a routine job on many models. Manufacturer warranties vary by product, and we explain what applies to the one you choose.
Signs a tankless water heater makes sense, or needs service
- Your tank heater is aging and you are weighing a replacement
- You want to free up floor space where the tank sits
- Hot water turns lukewarm or runs cold when more than one fixture is open
- An existing tankless unit shows an error code or shuts off
- The unit is noisy, or output has dropped over time
- A tankless heater that has never been flushed or descaled
How a visit goes
- We review your home and your hot water useWe look at how many bathrooms and appliances use hot water, where the heater will go, the gas or electrical supply and the venting route.
- We size the unit and plan the workWe recommend a unit that fits your demand and explain any gas line, venting or electrical changes it needs, before the work begins.
- We install or service the unitWe mount and connect the unit, vent it, add isolation valves for later flushing and test it. For service calls we diagnose the error code and repair or descale the unit.
- We review settings and careWe set the temperature, show you how to read the display and explain how often your unit should be flushed given your water.
Questions we hear
Will I never run out of hot water?
A tankless heater has no tank to empty, so it can supply hot water continuously. It does have a limit on how much water it can heat at once. If you run a shower, the dishwasher and the washer together, a unit that is too small may not keep up. That is why sizing matters.
Can I replace my tank heater with a tankless one?
Often yes, but it is more than a swap. Gas lines, venting and electrical capacity may need changes. We check your home and tell you what is involved before you decide.
Does a tankless heater need maintenance?
Yes. Mineral scale builds up inside it, especially with hard water, and periodic flushing keeps it working well. Isolation valves installed with the unit make that job easier.
Why does my tankless unit show an error code?
Codes point to a specific problem such as a venting issue, a flame or ignition fault, a sensor problem or a scaled heat exchanger. The code is a starting point. A technician checks the unit and the installation to find the actual cause.